Hinging & Hanging Doors:
• Place hinges about 2” from top and bottom of doors. Then secure the hinges on door to the frame. If re-using old hinges, place hinges so screws make new holes.

• If using Quality Doors concealed hinges, refer to instructions provided with hinges (F.21).

• When using hinges like our #900(F.3, pg. 9), screw into face of cabinet frame and center the door over the opening, allowing an equal margin of overlap on all sides (F.22). On openings with two doors, leave a gap of about 1/8” between doors.

Preparing old drawer box to accept new drawer fronts:
• When replacing the drawer fronts, you must first determine whether your drawer boxes are three-sided or four-sided.

• If the drawer front makes the forward wall of the drawer box, then you have a three-sided drawer box( F. 2 3 ) .

• If the drawer front is mounted to a separate piece that makes up the forward wall of the drawer box, you have a four-sided drawer box(F.25).

• Remove drawer slides from the old drawer box.

Three-Sided Drawer Box (F.23):
• Using a saw, trim the drawer front so that no edges extend beyond the top, bottom or sides of the drawer box (F.24). This allows the old drawer front to fit inside the drawer opening.

• Hide rough edges by turning the box around. The old drawer front should now be in the back of the drawer box.

• When using hinges like our #900(F.3, pg. 9), screw into face of cabinet frame and c e n t e r the door over the opening, allowing an equal margin of overlap on all sides (F.22). On openings with two doors, leave a gap of about 1/8” between doors.

• Replace drawer slides, making sure they are centered and flush with the front edge of the box.

• Center the new drawer front on the box and temporarily secure with screws (F.26).

• Slide the drawer box into the opening to check alignment. Adjust as necessary, then tighten the screws.

Four -Sided Drawer Box (F.25):

• Remove the old drawer front, being careful not to damage the drawer box.

• Re-attach drawer slides.

• Center the new drawer front on the box and temporarily secure with screws (F.26).

• Slide the drawer box into the opening to check the alignment. Adjust as necessary, then tighten the screws.